 |
|
|
| Related Topics: | starter bushing removal and replacement - I have an 1982 Diesel Rabbit. Lately the starter motor has been 'balky', encountering some kind of resistance. Taking the starter motor out is so simple that this seemed to be a good, thorough start to troubleshooting. The starter motor spindle that..
Alternator question - Hi I have a 1984 VW rabbit gti. The brushes are worn on my alternators voltage regulator. Can just the brushes be replaced? IF not I looked into getting a new regulator as they are only about $25. However I noticed that there are two sizes a 28 mm or...
92 Cabriolet heater core, it's supposed to be easy!?!? - I could really use some insight into this by someone who's done it. The heater core is accessible through a slot in the side of the heater box on the drivers side but it can only come out 4 inches before it runs into the pedal assemblies. I figured....
wishbone has some play in it.... - hi all, Can anyone give me some advice please........ I recently had my anti-roll bar brushes replaced and since then my Golf (4Motion if this makes any difference!) has been pulling to the left. Today I had it checked out and they think the cause is....
Automatic Vanagon Must Shift to Start - Well, my 91 Automatic Vanagon has a starting problem. About 65% of the time (and growing) I go to start her up there is no noise or cranking or anything from the engine area. The electric works fine at this time. If I shift it into N and then try to.. |
|
You can post new topics in this forum
You can reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
|
|
|
|
FAQ
Search
Profile
Private Messages
Log in
