Welcome to AutoBoardz.com!
FAQFAQ    SearchSearch      ProfileProfile    Private MessagesPrivate Messages   Log inLog in

Still running hot

 
   AutoBoardz (Home) -> Mitsubishi RSS
Next:  radiator cap question  
Author Message
Steph




Joined: Dec 30, 2008
Posts: 1



(Msg. 1) Posted: Tue Dec 30, 2008 8:13 pm
Post subject: Still running hot

I have replaced everything on my 95 eclipse new waterpump, timing belt, head gasket, and when i drive it for about 45 min if it night you can tell that its getting hot still the all of the windows are very fogging u can not see in front of you. what else is there to do?

 >> Stay informed about: Still running hot 
Back to top
Login to vote
Display posts from previous:   
Related Topics:
mirage running very bad - Checked with my comp and it told me the egr was bad .I then changed it runs the same took it to a friends repair shop his comp said the same .Help shakes bad stalls when in gear when i get up to speed car runs fine till i have to stop have the chech...

2ltr.cyclone cuts out when up to running temp. - 2ltr.cyclone cuts out when up to running temperature,previous history-blew water pipe and overheated and cut out, towed back,replaced water pipe and water now this problem. can anybody help please

Shogun 2.5 TD. Not running right after new cylinder head - After having a snapped valve, I've had to replace the cylinder head and one piston on my 20 year old Shogun 2.5 tubo diesel. After putting it all back together the engine runs, but not well. There is a rythmic knocking sound, as though two parts are..

3000 GT - Hey all, I just got a 3000 GT and was looking for some chatter about these cars. Picked one up inexpensively because the dealer said it had a rod knock. I've traced it down to a loose bolt in the clutch. Arrgh, and I have to remove the trans to make....

Balance shaft timing on Galant 2.0 SOC engine - I have seen numerous posts about the balance shaft timing issues on this Mitsubishi 2.0 engine. I have tried twice now to get the timing right without using the screwdriver (8 mm rod) to check the shaft position, and I still have a vibration in the..
   AutoBoardz (Home) -> Mitsubishi All times are: Pacific Time (US & Canada)
Page 1 of 1

 
You can post new topics in this forum
You can reply to topics in this forum
You can edit your posts in this forum
You can delete your posts in this forum
You can vote in polls in this forum



[ Contact us | Terms of Service/Privacy Policy ]