Edelbrock carb question - On most of the Edelbrock Performer Series carbs there are two vacuum ports on the front of the carburetor. One is a full-time vacuum port and one is a ported vacuum port. What is the purpose of the two ports? Which would be used for the vacuum..
SBC conversion to carb from efi - Hello all, I am a newbie whos retired. I am going to put a 1990 5.7/400tranny into a 1960 Rambler. I have taken the engine and tranny from the donor 1 ton van. The compression test resulted in 155-165psi. This van was owned by my v=company and was taken....
LED Strip Needed - Anybody know where I can get a red surface-mount LED strip? It needs to be a foot long with two mounting studs seven inches between centers - width is flexible but probably shouldn't be more than an inch. It needs to be sealed for exterior use. The..
4.3 gm distributer help needed - I know this is a rod-n-custom group but thought one of you people could help. I have 1991 gm 4.3 gm with a holley 4 bbl.on it.It has a distributer less set up.a ecm with a coil pack mounded on top and a timing sensor on bellow housing.The ecm has..
You can post new topics in this forum You can reply to topics in this forum You can edit your posts in this forum You can delete your posts in this forum You can vote in polls in this forum
FAQ
Search
Profile
Private Messages
Log in
