engine swap??

On Sep 28, 10:41 pm, "Les Benn" <lb....RemoveThis@cox.net> wrote:
> <realea....RemoveThis@hotmail.com> wrote in message
>
> news:1191003653.832107.15930@n39g2000hsh.googlegroups.com...> just wondering what motors will bolt right up, or without much work
> > bolt up? i no about the 350 small block engines, but im lookin for
> > somthin a little easier on gas. i was thinkin a 3.8 or somthing around
> > there, any suggestions?
>
> Well the 3.8 and 3.4 Pontiac engines will fit right in without too much
> problem.
> check out the fiero online service guide

what about the transmision? would i have to change that?
 >> Stay informed about: engine swap?? 

<realeast7.TakeThisOut@hotmail.com> wrote in message
news:1191207083.272961.151380@w3g2000hsg.googlegroups.com...
> On Sep 28, 10:41 pm, "Les Benn" <lb....TakeThisOut@cox.net> wrote:
>> <realea....TakeThisOut@hotmail.com> wrote in message
>>
>> news:1191003653.832107.15930@n39g2000hsh.googlegroups.com...> just
>> wondering what motors will bolt right up, or without much work
>> > bolt up? i no about the 350 small block engines, but im lookin for
>> > somthin a little easier on gas. i was thinkin a 3.8 or somthing around
>> > there, any suggestions?
>>
>> Well the 3.8 and 3.4 Pontiac engines will fit right in without too much
>> problem.
>> check out the fiero online service guide
>
> what about the transmision? would i have to change that?
>

Not necessarily, but if you have an automatic, it probably makes sense to
use the trans that comes with the engine, most likely a 4 speed 4T60. I any
event, visit and register on Pennocks, there is tons of info on swaps.
http://www.fiero.nl/cgi-bin/main.cgi
Best Regards,
Mark
 >> Stay informed about: engine swap??