TV Cable adjustment on 700 transmission

Hi,

I have ben trying to adjust the TV Cable on this transmission according to
this site:

http://www.tciauto.com/Products/Instructions/instructions/gm_tv_cable_adjust.htm
It shows I press an adjustment tab and push the the slider backwards


I was looking at a diagram at this site on how to adjust with the cable
housing as it is an area that has been a bit of confusion on how to
"operate."


http://www.purplesagetradingpost.com/sumner/techinfo/700R4p1.html


Figure 15 on a copy of a page from a service manual shows how the assembly
should look like when doing the adjustment. It helped a lot, however it
mentions pressing a lock tab and pulling out the slider.

So here we are with 2 different explanations.


Anyway I press on this adjustment tab/lock tab.

Any advice on pressing the lock/adjust tab so I won't break anything? I
notice a dimple on it...is that really a hole which to stick a paper clip in
to get it to release?

Thanks so much.

GB

"GeekBoy" <nerd_revenge RemoveThis @nerdythree.net> wrote in message
news:crgEk.1681$x%.1504@nlpi070.nbdc.sbc.com...
> Hi,
>
> I have ben trying to adjust the TV Cable on this transmission according to
> this site:
>
> http://www.tciauto.com/Products/Instructions/instructions/gm_tv_cable_adjust.htm
> It shows I press an adjustment tab and push the the slider backwards
>
>
> I was looking at a diagram at this site on how to adjust with the cable
> housing as it is an area that has been a bit of confusion on how to
> "operate."
>
>
> http://www.purplesagetradingpost.com/sumner/techinfo/700R4p1.html
>
>
> Figure 15 on a copy of a page from a service manual shows how the assembly
> should look like when doing the adjustment. It helped a lot, however it
> mentions pressing a lock tab and pulling out the slider.
>
> So here we are with 2 different explanations.
>
>
> Anyway I press on this adjustment tab/lock tab.
>
> Any advice on pressing the lock/adjust tab so I won't break anything? I
> notice a dimple on it...is that really a hole which to stick a paper clip
> in to get it to release?
>
> Thanks so much.
>
> GB
>

GB,
I just used my thumb. And I pushed BACK on the slider toward the firewall.
Then push the pedel to WOT.
That will get youy close. After that only adjust it one click at a time.
It's touchy.
Regards,
JR