Welcome to AutoBoardz.com!
FAQFAQ      ProfileProfile    Private MessagesPrivate Messages   Log inLog in

RPM fall down and the car stop

 
   AutoBoardz (Home) -> Mitsubishi RSS
Next:  horrible noise  
Author Message
yann




Joined: Sep 08, 2008
Posts: 1



(Msg. 1) Posted: Mon Sep 08, 2008 3:30 am
Post subject: RPM fall down and the car stop

i have a verada 92 SW
the car has 143000 km
and since a week a saw the rpm of the car falling down when i stop at a light and the car stop when 2km before everything was fine
the battery is ok i don`t have any problem to restart
and after sometimes the rpm come back to normal!
someone have any idea where the problem came from?
thank you

 >> Stay informed about: RPM fall down and the car stop 
Back to top
Login to vote
Stewart DIBBS

External


Since: May 02, 2005
Posts: 315



(Msg. 2) Posted: Tue Sep 09, 2008 7:14 am
Post subject: Re: RPM fall down and the car stop [Login to view extended thread Info.]
Archived from groups: per prev. post (more info?)

"yann" <none RemoveThis @000.com> wrote in message
news:1209871_f05b51f09870ffe297fff1974ef7f2cc@autoboardz.com...
>i have a verada 92 SW 143000 km
> and since a week a saw the rpm of the car falling down when i stop at
> a light and the car stop when 2km before everything was fine

Does this happen when the gas tank is less than 1/4 full? If so could be
the fuel filter (cannister on the firewall) needs replacing or at least
removing and blowing backwards with compressed air. Might also be the fuel
pump. More likely is that the gas tank evaporative system is blocked in some
way. Try running (briefly) with the gas cap open to see if the problem
persists.

Also check for error codes from the ECU. The error port is under the dash
above the brake pedal. Get a 12V LED (or an ordinary 2V LED with a 470ohm or
so 1/2W resistor). Connect across the error port diagonal pins so the LED
flashes. A long flash = 10, short = 1. Hence say error 24 = 2 long 4 short.
Normal operation is a continous stream of short flashes.

regards
Stewart DIBBS
www.lancerproject.ca

 >> Stay informed about: RPM fall down and the car stop 
Back to top
Login to vote
Bhagat Gurtu

External


Since: Jul 22, 2008
Posts: 5



(Msg. 3) Posted: Wed Sep 10, 2008 6:52 am
Post subject: Re: RPM fall down and the car stop [Login to view extended thread Info.]
Archived from groups: per prev. post (more info?)

On Mon, 08 Sep 2008 11:22:06 -0500, yann wrote:

> i have a verada 92 SW
> the car has 143000 km
> and since a week a saw the rpm of the car falling down when i stop at a
> light and the car stop when 2km before everything was fine the battery
> is ok i don`t have any problem to restart and after sometimes the rpm
> come back to normal! someone have any idea where the problem came from?
> thank you

Secure your RPM with a string, so that it won't fall down when you stop.
 >> Stay informed about: RPM fall down and the car stop 
Back to top
Login to vote
Display posts from previous:   
Related Topics:
3000 GT - Hey all, I just got a 3000 GT and was looking for some chatter about these cars. Picked one up inexpensively because the dealer said it had a rod knock. I've traced it down to a loose bolt in the clutch. Arrgh, and I have to remove the trans to make....

Balance shaft timing on Galant 2.0 SOC engine - I have seen numerous posts about the balance shaft timing issues on this Mitsubishi 2.0 engine. I have tried twice now to get the timing right without using the screwdriver (8 mm rod) to check the shaft position, and I still have a vibration in the..

Colt - Had a 3- door Mitsubishi Colt as loan car for a day Thurs. It had only done 1600 miles, but was it noisy. I couldn't get back to the dealer quick enough. A mixture of road noise and what sounded like noisy wheel bearings. I would avoid one of these.

92 Eclipse - I just purchased a nice eclipse for 150 it is a 92. When I say nice I mean the body and the interior is nice. The car however does not start. I was told the car needs clutch. When I went to pick up the title and keys I attempted to start it. When th...

95 mits. galant auto 155000mi - hi, as previously noted here my car would start and stall it does run just keeps stalling.i was told i need an engine or a valve job. after everything was supposedly checked including compression test #1 cylinder 200lb. #2 cyl.200lb #3 180lb and #4 180lb...
   AutoBoardz (Home) -> Mitsubishi All times are: Pacific Time (US & Canada) (change)
Page 1 of 1

 
You can post new topics in this forum
You can reply to topics in this forum
You can edit your posts in this forum
You can delete your posts in this forum
You can vote in polls in this forum



[ Contact us | Terms of Service/Privacy Policy ]