My Neon 1996 Keep stalling and giving me P0300 and p0301

neons had a problem with oil leaks from head gasket. that oil soaked the
harness under the exhaust manifold. the crank sensor wiring is in that
location. the computer monitors the crank shaft speed to determine
misfires. if swapping the plug wires 1 and 4 doesnt change the misfire and
you have equal compression on all cylinders. that would be a good place to
look. that part of the harness is easy to repair since there are not that
many wires in that branch. also had the same problem near the cam sensor,
your problem is more likely to be from the crank then the cam area. the
wires would become fused together from the heat and oil the insulation would
break down and cause an intermitant stalling condition when hot. also check
your crank sensor for any leaks out of the connector. crank sensor is
located under the alt.
good luck.
Bryan

"michastef" wrote in message

> Hi, my neon 1996 keeps stalling after 30-60 minutes of driving and it
> gives me the code P0300 and P0301, i change the spark plug and cleared
> the code, no change, the code came back and it keep stalling, but only
> when it's hot.
>
>
> Someone can help me?
>
> Thanks a lot
>
> Stef
>
> --
> Posted at author's request, using moderated http://www.AutoBoardz.com
> interface
> Thread archive:
> http://www.AutoBoardz.com/Neon-1996-stalling-giving-P0300-p0301-ftopic...9667.ht
 >> Stay informed about: My Neon 1996 Keep stalling and giving me P0300 and p0301 

I changed the wire and the coil too, but the problem keep coming back, i'm gonna check the wire of the crank sensor, thanks alot, for the help, if my crank chaft sensor would be faulty, would'nt I have a code that would light?

I 'll try to check the wire and i'll come back to tell you if it works, thanks again :O)
 >> Stay informed about: My Neon 1996 Keep stalling and giving me P0300 and p0301