Interior Door Panel

http://Hyundai-SantaFe.autoboardz.com/2002-C240-door-panel-ftopict198595.html (2002 C240 door panel)
Does anyone have any info on how to disassemble the front passenger interior door panel on a 2002 C240? I need to replace a broken door pull and I am sure if I have the dealer do it will be very expensive for probably a simple procedure.

http://Hyundai-SantaFe.autoboardz.com/rabbit-door-panel-ftopict217129.html (rabbit door panel will not come off)
Hi all, I am hoping once again that you may be able to help me out as you have in the past. I am trying to get the interior door panel off my 83 rabbit- however I am having one problem. The control knob for the side mirror will not come off. I have tried prying as well as it turning it and yet ..
« IIRC the outer ring of mirror adjuster simply just un-screws , to get it removed. »
« Knob is round, plastic and about 3/4"? AFAIK it should pull off but maybe some glued it on. You might be able to pull the panel off over the knob and its seal. DO THIS AT YOUR OWN RISK! A picture wo.. »
« Sorry no poicture. I believe it is a metal ring, and is about 3/4 inch round, inside it has four small notches spaced evenly around on the inside bit of the ring. It makes me think maybe there is .. »
« Sorry but I just don't remember then. It has been too long since I have really seen a Rabbit (first generation USA Golf) and those remote control mirrors were rare. A picture would help, but the .. »

http://Hyundai-SantaFe.autoboardz.com/2000-Grand-Prix-Interior-Door-Panel-Trim-ftopict221584.html (2000 Grand Prix Interior Door Panel Trim)
I am trying to locate a source for the piece of black plastic trim that resides at the top of the front door interior panel on a 2000 Grand Prix GT coupe. This trim resides between the window and the top of the upholstered interior door panel and I suspect this identical trim is used on multi-..
« Hi Ray, Did you find this part? It sounds like exactly what I need. I have a 2000 GTP. Thanks, Tom please reply to »

http://Hyundai-SantaFe.autoboardz.com/Install-mirror-63-early-ftopict222245.html (Install O/S mirror on 63 early?)
I see that the correct mirror ( longbase)is specific to my 63E. Does the interior door panel need to be removed to install a mirror correctly or is it done externally? The driver side has been replaced with a generic mirror.I am considering replacing it and doing a new install on passenger sid..
« Yes, the door needs to have the interior removed and a new reinforcing plate put under the right side mirror. Location should match the left side as right side was not factory, although there may .. »
« Thanx for info, once again, Dad. Yes, I have fotos of car during project and also on run back home. I know I can't post them on this NG and I don't have a website of my own, so am a bit in the dar.. »
« Easy. All you need is a photo hosting spot and then put the links here. For example, you can go to tinypic.com and upload pictures free and put the links here. The first one gives you the tinypic.. »
« One added note, if you change the drivers side mirror it should already have a backer plate with holes threaded in it which will save you removing the interior. Rik's have been a good outfit to wo.. »