Front Turn Signal

http://Hyundai-SantaFe.autoboardz.com/1997-ES300-Left-front-turn-signal-light-bulb-ftopict191167.html (1997 ES300 Left front turn signal light bulb)
I fixed my 1992 ES300 last summer -- same bulb. Ridiculous pain in the ass. Had to pop off a bunch of the little things that hold down the rubber cover that goes across the hood above the light. Broke most of them. Had to unbolt the whole light assembly. Lost the headlight alignment. Etc. I..
« If the 1997 is the same as my 2000, and I think it is, you open the hood, and pry a thin black plastic strip up that runs above the turn signal over towards the radiator. Below that is one phillip.. »
« After I've shined up the contacts, I put a little dielectric grease in there. »

http://Hyundai-SantaFe.autoboardz.com/HELP-Replace-Front-Turn-Signal-Lamp-ftopict211531.html (HELP: How To Replace Front Turn Signal Lamp?)
I hope someone can kindly tell me how to get to the front signal light housing? I need to replace a bulb or two in those areas but can't seem to figure out how to get to them. I was able to change the signal bulbs of the rear lights but the front ones seems a little challenging. I am refering t..
« not too sure about your '96 but on my 2000 it was fairly easy to remove the headlight assembly and go in from above. »
« I have a 2000, and my signal lights blow all the time. Their diffnitely alot more aggrevating to change in the front. There's really no easy way to do it. You can reach in from the top, or get under.. »

http://Hyundai-SantaFe.autoboardz.com/install-front-turn-signal-Saab-ftopict225148.html (how to install front turn signal on Saab 9.3)
I have a 1999 Saab 9.3 and the other day, the right hand turn signal mysteriously disappeared, leaving only the power connectors behind. I ordered a replacement from the Internet, and can connect the lights and they function correctly. My problem is physically placing the turn signal into the fra..
« Are you sure you've got the right part? I seem to remember it being easy, though the workshop manual has a note saying "Be careful when fitting the light cluster so that the hook in the front edge a.. »
« I am pretty sure it is the right part. It does look like the other side. The screw has been removed temporarily. I can either fit the front end and the back will not work or the other way around... »
« I fiddled with one on my 2001 car ages ago whilst I was replacing a headlight glass. It seemed to just slide in and out without any effort. Perhaps I just got lucky. OMG - double entendre overload! .. »
« There are only two attachment points that matter. On the rear there is a little clip that hooks behind the fender. On the front, the one screw at the top holds it in place. You just plug in the con.. »

http://Hyundai-SantaFe.autoboardz.com/94-Trooper-ftopict227847.html (94 Trooper)
I have an problem with the front turn signal .. driver's side ... it works fine for a period of time and then the bulb fails to flash .. and blinker gizmo clicks rapidly (usually indicating dead bulb). The rear turn signal is flashing though .. at 'double speed'. Fine .. replace the front..