Welcome to AutoBoardz.com!
FAQFAQ    SearchSearch      ProfileProfile    Private MessagesPrivate Messages   Log inLog in

Colt

 
   AutoBoardz (Home) -> Mitsubishi RSS
Next:  90 MONTERO WON'T START--WHAT TO LOOK FOR ???  
Author Message
Spanner

External


Since: Aug 22, 2006
Posts: 20



(Msg. 1) Posted: Sun Nov 12, 2006 12:06 am
Post subject: Colt
Archived from groups: alt>autos>mitsubishi (more info?)

Had a 3- door Mitsubishi Colt as loan car for a day Thurs. It had only done
1600 miles, but was it noisy. I couldn't get back to the dealer quick
enough. A mixture of road noise and what sounded like noisy wheel bearings.
I would avoid one of these.

 >> Stay informed about: Colt 
Back to top
Login to vote
Display posts from previous:   
Related Topics:
Colt loosing water - I have a colt Pioneer 2800tdi You fill the radiator with water, you can then drive for about 5km before the vehicle overheats. What could be the problem. There is no visible place where the water is lost. Any ideas

85 colt auto stuck in park. - i have an 85 colt, i believe the parking pin may have brocken off into the flywheel, it goes into the selected gear but it doesnt engage, just wondering if there was an easy way to get the brocken parking pin out? cheers for the help :) .

mitsubishi colt clutch stuck so gearbox doesnt move car. - can change gear fine but when in gear car has no drive at all. when ive had a clutch go before u cant change gear which leads me to beleive its not gonna be as straitforward as jus changing the clutch. can anyone help and give me some advice on fixing th...

3000 GT - Hey all, I just got a 3000 GT and was looking for some chatter about these cars. Picked one up inexpensively because the dealer said it had a rod knock. I've traced it down to a loose bolt in the clutch. Arrgh, and I have to remove the trans to make....

Balance shaft timing on Galant 2.0 SOC engine - I have seen numerous posts about the balance shaft timing issues on this Mitsubishi 2.0 engine. I have tried twice now to get the timing right without using the screwdriver (8 mm rod) to check the shaft position, and I still have a vibration in the..
   AutoBoardz (Home) -> Mitsubishi All times are: Pacific Time (US & Canada) (change)
Page 1 of 1

 
You can post new topics in this forum
You can reply to topics in this forum
You can edit your posts in this forum
You can delete your posts in this forum
You can vote in polls in this forum



[ Contact us | Terms of Service/Privacy Policy ]