96 Signal lights flashing after ignition turned off

Joe wrote:
> Hi some things to check. Ensure that the hazard switch isn't sticking on,
> (operate harshly to unstick works sometimes) An alarm fault. A bad earthing
> point.
>
> Joe
>
> "Jurgen" <bratworks DeleteThis @hotmail.com> wrote in message
> news:imdCf.14374$ft2.250446@news20.bellglobal.com...
>
>>Vehicle: 1996 4Runner, SR5 V6, 5 speed manual
>>
>>Problem: Signal and dash lights flash and chime sounds after turning off
>>ignition and removing key.
>>
>>Help
>>
>
>
>
Thanks for replying. The hazard switch is fine - the lights only flash
after the engine is off and the key has been removed... However, the
aftermarket alarm system, that's had its power disconnected for some
time, may be the culprit - my weekend project to clean it up...

Jurgen
 >> Stay informed about: 96 Signal lights flashing after ignition turned off