http://Toyota.autoboardz.com/96-Gr-Caravan-Stalling-ftopict203527.html (96 Gr. Caravan Stalling)
I have come here before and gotten some good advice, and once I need some advice. I own a 96 Grand Caravan (3.8 engine) that has been stalling on me when I am at a stop. It is totally random, and without warning. Background information...... back in November van died and had it towed home. Hubby ..
« take a look at the crankshaft or camshaft positioning sensor the one near the distributor coil. I have a 96 grand caravan and it was stalling at any given time and when I changed the sensor near th.. »
« My 1992 Caravan with 3.0 liter engine had varnish buildup in the throttle body that caused it to stall while waiting at a stop light. »
http://Toyota.autoboardz.com/96-Grand-Caravan-Blowing-Ignition-Coils-ftopict217305.html (96 Grand Caravan Blowing Ignition Coils)
I have a 96 Dodge Grand Caravan 3.3L V6 w/ 140K miles. Engine suddenly began running rough, check engine light came on, and vehicle stalled after another minute or so. Mechanic replaced Cam Sensor and Ignition Coil. Vehicle started up and ran fine for about five miles and then same thing happen..
« I'd bet crank sensor. It's not bad practice to replace both cam and crank sensor as a set. You see what happens is over time the fine wiring in the sensors cracks. Then when they heat up, the wir.. »
« Your "mechanic" is an idiot. P0351 doesn't mean the coil is no good. It means the PCM has detected a problem in the #1 coil circuit. It "could" be caused by a bad coil, but there are other possibili.. »
« The ignition coil is supplied 12 volts by the ASD relay to ignition coil primary circuit 1-2 and 3.The PCM controls all 3 primary circuits by grounding each circuit. The problem could have been a ba.. »
http://Toyota.autoboardz.com/CARAVAN-WIPER-INFO-ftopict225692.html (CARAVAN WIPER INFO)
I have a 96 grand caravan and am having trouble with the wipers not turning off right away when you select the off position or what will happen is that they will stop in the middle of their cycle instead of stopping in the proper park position. I suspect there is a stop position switch located ..
« The wiper motor has a park switch built into it the will stow the arms in the down position once the switch or key is turned off. Keep in mind that a faulty BCM or even a multifunction switch could .. »
« Thanks for the info Glenn, I will look tomorrow and see if I can get the wiper motor out and have a look at the switch. I find lately that if we only get light rain or short periods of heavy rain .. »
« Bill im sorry but I cant recommend a good scan tool, we use the Chrysler scan tool and the last time I priced it was $2800.00. Don't waste your time pulling the wiper motor because the park switch i.. »
« Thanks for the info Glenn, sounds like I will have to put up with the wipers the way they are for a little while longer CHEERS Bill »
http://Toyota.autoboardz.com/96-Caravan-codes-running-rough-ftopict235633.html (96 Caravan codes? running rough)
I have a 96 Grand Caravan LE with a 3.3L motor it's running very rough or carboned up put put & not wanting to idle. I checked for codes using the check engine light and got these number can someone point me to the problem. I did find a broken vaccum line which I replaced but still running bad..
« A scan tool is needed to read fault codes on that vehicle. when was the last time this vehicle had a good set of plugs and wires installed? Glenn Beasley Chrysler Tech -- Message posted using More.. »
« don't know I just bought the van, I will be pulling a few plugs to check today. »
>> Stay informed about: 96 Grand Caravan