"Keith W" <invalidaddress.DeleteThis@invalidaddress.invalid> wrote in message
news:g9o85g$71g$1@news.albasani.net...
>
> "Chris" <chris.DeleteThis@orbsrealm.com> wrote in message
> news:20080902194133.676e50c6@compaq...
>> Sorry Keith i have been looking back and cant find any thing about
>> doors.it might be a case of keep trying to unlock it and pulling the
>> door at same time
>
> Thanks for looking. I did find a couple of references to it but nobody
> seemed to have come up with an answer. The problem appears to be that
> the lock is not releasing, certainly the inner and outer handles react
> exactly as when locked and the locking lever has less tension behind it as
> if the linkage is remaining in the locked position. I suspect that the
> only way around it will be to try and remove the inner door panel while
> the door is closed. Obviously I can remove the seat squab to make more
> room, and the seat back can be folded forward as necessary, but it will
> still be pretty difficult. Maybe I can persuade my son-in-law that he
> is more agile than me ;o)
Fixed, at least for the moment. Here are the details for anyone else with
similar problems.
It is possible to get the panel off with the door closed, although a bit
strenuous. Having said that, I avoided the strenuous bit.
Haynes is accurate in this case. You pull off the window winder (mine has
manual rear windows) and then remove the front and rear trim securing screws
from the ends of the grab handle. The rear one is under a cover. Note
that the rear one drops inside the panel if you are unlucky. This is not a
problem if you are removing the panel, but if you are replacing it....!
Anyway, they came out. Haynes then says remove the surround from the door
opening handle and then prise the bottom of the panel away from the door.
This will pull out the retaining pins and you then manoeuvre the panel up
and off. That would have been the strenuous bit. In the event, I pulled
on the door opening handle to make it easier to remove the surround
and - - - the bloody door opened - it had cured itself again like last time.
Anyway, I removed the panel, carefully removed the inner insulation sheet as
far as necessary and gave all the door opening and locking components a good
lubricating with silicone lubricant. At this moment it is all working
fine again but for how long.....?
--
Keith W
Sunbury on Thames
(If you can't laugh at life, it ain't worth living)
>> Stay informed about: 406 - Stuck Rear Door 
FAQ
Profile
Private Messages
Log in
