2000 Toyota Camry

http://Hyundai-SantaFe.autoboardz.com/2000-toyota-camry-mysterious-warning-light-dash-ftopict234161.html (2000 toyota camry mysterious warning light on dash)
Our car didn't come with the manual, and I've searched around without any luck. Recently a warning light has come on in the lower left hand side of the dash area. it's red in the shape of the car from above, and there are little lines coming out the back where the rear lights would be. i checked a..
« Try registering on the Toyota.com site. They have a section for owners. Jeff »
« Did you check the high mount stop light in the rear window? Scott »
« That icon is the warning indicator that one of the rear lights is not working. As zonie suggested, check the center high mounted stop lamp, turn signals, backup lights, and license plate lights. .. »

http://Hyundai-SantaFe.autoboardz.com/2000-Toyota-Camry-LE-Problem-Gas-Tank-Sensor-Problem-ftopict233211.html (2000 Toyota Camry LE Problem (Gas Tank or Sensor Problem?))
Hello, I am hoping someone in this newsgroup can offer some ideas to help figure out a problem that persists with my 2000 Camry LE, which has the V-6 engine. Whenever I try to fill up the gas, the pump automatically cuts off, as if the tank is full. This problem even persists when the tank is comp..

http://Hyundai-SantaFe.autoboardz.com/2000-Camry-Start-ftopict224649.html (2000 Camry Won't Start)
I got back from a trip and my car wouldn't start. It makes a very quick repeated clicking noise. I think it may be the starter. My mom noticed that the trunk was left open, and closed it a couple of days after I left. The lights work just fine. I tried a battery charger briefly and amp readin..
« == Try leaving the battery charger on over night. »
« Definately listen to Daniel. Lights working don't mean the battery is charged enough to turn over the engine. »

http://Hyundai-SantaFe.autoboardz.com/2000-Camry-P0446-code-ftopict224828.html (2000 Camry six with P0446 code)
It may help others to know that I tracked down the source of the problem to the Vacuum Switching Valve for the Pressure Sensor mounted on the canister. It was stuck open. I took it apart and found the little piston had rust on it. (had to force it out with compressed air). I sanded the rust,..
« "Fred Buchholz" wrote in It may help others to know that I tracked down the source of the problem to the Vacuum Switching Valve for the Pressure Sensor mounted on the canister. It was stuck open... »

http://Hyundai-SantaFe.autoboardz.com/Suspension-Issues-Camry-2000-LE-ftopict232584.html (Suspension Issues On Camry 2000 LE)
Hi: I have a 2000 Camry LE 86K miles Replaced the Front struts 8 months ago (KY) Replaced the Rear struts 2 months ago (Gabriel?) Replaced brakes for front and rear 2 months ago Replaced all four tires 2 months ago Heres the problem when I am riding on level road ... no issue when I run over uneve..
« If I were a betting man, I would bet the strut mounts are bad. I replaced all four struts on my mother's 1999 Camry with Monroe Quick Struts. Safe, simple and fast installation. Quick strut include.. »
« Monroe's QuickStrut is an excellent way to change out the assembly. I would have gotten one with the new Reflex. I went with Gabriel Ultra because the SensaTrac has the "grooved" piston rod. Probabl.. »

http://Hyundai-SantaFe.autoboardz.com/2000-Camry-Trans-Service-Wheel-Bearing-ftopict235600.html (2000 Camry Trans Service and Wheel Bearing)
I have a 2000 Camry with 172K miles. It is time for the transmission to be serviced. The last time i had the typical flush and fill where they hook up the car to a machine that pushes new fluid into the transmission and the old out. Right now i have a minor leak around the pan so i know i need ..
« I'm in the camp of not using the flush machine. First of all the machine can't clean out the sediment at the bottom of the pan or clean the magnets; second, a dirty strainer will be just as dirty af.. »
« Make sure it's the bearing and not sticking brakes grinding on the drum/rotor. A friend with the proper knowledge and access to a press willing to help out is cheaper, just buy a case of beer Se.. »

http://Hyundai-SantaFe.autoboardz.com/2000-Camry-brakes-unresponsive-cruise-control-ftopict224931.html (2000 Camry brakes sometimes unresponsive in cruise control)
Hi, I recently bought an automatic shift 2000 Camry LE with 66K miles in pretty good condition. The cruise-control seems to work fine; I have used it multiple times with no problems. However, twice, with cruise- control engaged, when the car was accelerating to the cruising speed, I tried hitting ..
« This is a dangerous safety issue and I would caution you in not driving the car at all until this problem is resolved. Look or have someone knowledgeable look for any obstructions to brake pedal m.. »
« The brakes are an essentially foolproof hydraulic system that operates independently of the cruise control. Likewise, whether the lights work or not is a completely separate issue. Have a look u.. »
« That means the OP will not take it to -Jiffy Lube -Wal Mart -Pep Boys -Sears »
« LOL! I guess I should have been a bit more qualifying in the description of knowledgeable, but I did mention the Toyota dealer, hope he can read into that. »

http://Hyundai-SantaFe.autoboardz.com/Camry-2000-Noise-rolling-driver-side-window-ftopict234867.html (Camry 2000 - Noise when rolling up driver side window)
Hello All, My Camry 2000 is making a "Drrrr" kind of noise when rolling up the driver side window as is something is shaking or trembling. It does "not" make the noise when rolling down though. Other windows are working fine. Please help me in diagnosing this. All tips/suggestions welcome.
« Sounds like the regulator mechanism may be binding up. You might want to remove the door panel and lube the moving parts. Spraying some silicone in the track might help too. »
« I want to attempt to lubricate the window regulator. For this, I should be taking off the door panel, right ? Not the whole door, right ? Also, I had the master power switch changed last year at an .. »
« Finally took off the door panel but saw that removing the regulator would be difficult. So took it to local mechanic. Parts was $50 and labor was $60. I had ordered the parts online. Now, the proble.. »

http://Hyundai-SantaFe.autoboardz.com/2000-V6-Camry-cam-crank-seal-leaking-ftopict232284.html (2000 V6 Camry cam and/or crank seal(s) leaking)
Noticed a little bid of oil under the car but no oil on the garage floor. Car has about 50k miles so do I do the timing belt, water pump and crank/cam seal replacement thing now or wait till 80k miles?
« You should find out where the oil is leaking -- probably the rear valve cover gasket. It's a known problem with the V6. 50K miles and these rubbers start to weaken sounds about right. It may also be.. »
« Thanks for the info, John. »