Tacoma 1996 - replacing starter

swimbikerun wrote:
> Hey all. I'm new here. I'm replacing my starter and need some help. I
> was able to get to the mounting bolts and have removed the old one, but
> getting it out of the engine bay is another story. What mounts, lines,
> etc. can I easily remove that will allow me to get the starter out and the
> new one in?

If it is a 2.7 liter i can be done with out removing anything i had to
turn my starter over and twist it try to get it past the steering shaft
i took a little while i've done it twice.
 >> Stay informed about: Tacoma 1996 - replacing starter 

i have a 1994 4cly 4x4 just did this 2 weeks ago on the right fender well
took off rubber splash guard then a small plate of the fender well did not
have to even get under the truck or take the right front tire off did it all
from over the tire i should have taken the tire off but i am not a big guy
so i fit in also lazy good luck let me no if this helps benryer RemoveThis @suscom.net
"swimbikerun" wrote in message

> Hey all. I'm new here. I'm replacing my starter and need some help. I
> was able to get to the mounting bolts and have removed the old one, but
> getting it out of the engine bay is another story. What mounts, lines,
> etc. can I easily remove that will allow me to get the starter out and the
> new one in?
>
 >> Stay informed about: Tacoma 1996 - replacing starter